Replace the Shell with a Nintendo DS Lite

The Ds lite Lite is usually a gaming device which offers portability for players to savor their best games away from home. The Ds lite by nintendo incorporates a built-in backlight behind the LCD so gamers can begin to play at midnight, an extremely improved feature from the regular Nintendo DS predecessor. However, portability could mean disaster if your device is accidentally dropped or crushed. With a few tools plus a new ds lite shell, which may be purchased coming from a third-party online retailer, your Nintendo DS Lite looks good as new. Retailers are available by searching "Replacement Nintendo ds Shells" or browsing eBay.

1.Remove any Ds lite games through the cartridge slot. Eliminate the battery cover to secure it.

2.Take away the six tri-wing screws on the bottom from the device which has a tri-wing screwdriver. The foot of the custom ds lite shell should easily be removed with the tri-wing screws out.

3.Locate the black clamp near the back edge at the base of the device. Open the clamp by swinging this and coitus interruptus the bus.

4.Get the brass connector, which is based in the middle of the bottom with the device. Pull against eachother gently mainly because it ought to be associated with a black wire.

5.Unscrew the hinge cover from the bottom of the Nintendo ds that has a Phillips-head screwdriver. Unscrewing the hinge cover will let you remove the the top of shell.

6.Remove the rubber covers upon the top shell to reveal four screws. Remove these along with your Phillips-head screwdriver.

7.Find a small slit along the top shell. Start using a small flat screw driver and run it across the slit before upper layer in the top shell is removed.

8.Apply constant pressure towards the hinge whilst you eliminate the DS Lite's top shell. With the hinge dismantled, connect the bus with all the black wire you removed from the clamp in steps 3 and 4. Take a new replacement shell bottom make it back beneath the Nintendo ds. Occurs tri-wing screwdriver to screw the six tri-wing screws back into place.

9.Unscrew both circuit boards make everything into your new ds lite housing case. Examine carefully design of all the components when putting transferring the components towards new housing.

10.Fix the metal hinges to its original position and push on the hinges prior to the top shell fixates itself while using the hinges.

11.Re-attach the bus and wire through the new shell slot. Crack down the bus and be sure the buttons are fastened tightly in the new shell. Confirm the power and charge light to be certain they may be of their original places in the shell.

12.Screw and snap the top and bottom components of the shell back together.