The best way to Install LED Lights within an Xbox 360 elite Controller

Xbox will be the latest console from the makers at Mircrosoft. An ordinary xbox 360 controllers offered with the console's purchase; however, other designs of special controllers are offered seperately. LED lights may be placed on any Xbox 360 elite controller to produce the buttons and triggers light.

Instructions

1. Eliminate the battery power on the back of your Xbox controller. If the battery pack is removed, unscrew every one of the screws that offer the plastic covering constantly in place, such as one within the power supply slot.

2. Get rid of the plastic covering to show the controller's motherboard along with other internal components. Intoxicate for the motherboard and take away it from the faceplate on the controller. The everywhere you look virbating pieces are attached by wires, so you should definitely lift those up, and so the wires will not disconnect.

3. Solder the bad and the good wires on the underside of every LED light, ensuring that to make note of and that is which. Locate the 4 tiny copper holes directly in the center of the controller also to the left on the joystick; fundamental essentials holes the location where the positive wire should be soldered. Locate a few tiny copper holes simply to the best from the joystick, because these are the location where the negative wires really should be soldered. Solder all of the negative wires in situ before moving on to the positive wires.

4. Glue the LED lights to the bottom of the clear trigger pieces and the end of each and every from the A, B, X, and Y buttons.Eliminate the old white trigger pieces and replace all of them with the new clear pieces; these will just start up and into place very easily.

5. Await everything to dry fully then reassemble the controller by putting each piece extremely popular exact spot from where rrt had been removed. Finally, rescrew each of the five screws back to place to reattach the rear plastic covering. If the battery power in reinserted, the controller and newly installed LED lights work properly.