Tips on how to Remove a Nintendo ds lite Screen

The Ds lite Lite is included with two LCD screens to improve the overall game play. The LCD screen which is coupled to the lid can go wrong whether its wiring studying the hinge holding it to the top with the DS gets broken. You can get rid of the LCD screen through the the surface of the DS to repair the wiring or replace the LCD screen altogether. While removing the LCD screen voids the Nintendo warranty, it will let you more quickly repair or replace the LCD screen to be able to get back to winning contests.

Instructions

1. Place the towel down on a table Position the Nintendo DS Lite faced down for the towel. Insert the flat-edged jeweler's screwdriver into your seam between the ds lite battery compartment lid as well as the bottom with the Nintendo ds lite. Wiggle the tip with the flat-edged jeweler's screwdriver to lift off battery compartment lid. Place the battery compartment lid aside.

2. Insert the flat-edged jeweler's screwdriver underneath the battery inside of the battery compartment. Wiggle it loose. Squeeze ds lite charger aside.

3. Get rid of the six screws from about the back edges with the Nintendo ds with all the Phillips jeweler's screwdriver. Take away the screw from the inside with the ds lite battery ( http://www.vdealbox.com/ds-lite-accessories/ds-lite-battery-charger.html )compartment using the Phillips jeweler's screwdriver.

4. Insert the Phillips jeweler's screwdriver into the bottom center on the Ds by nintendo and wiggle it down to loosen the rear cover on the front cover. Lift the rear cover and off the front cover with your fingers. Squeeze back cover aside.

5. Orient the top cover so that the circuit board is facing upwards, while using long, copper colored tube farthest from you.

6. Remove a screw from they can be kept on the board that is at intervals of end and even with all the long black computer chip.

7. Pull out small black plug from your card that is certainly around the right side with the metal bracket towards the bottom with the front cover while using the needle nosed pliers. Scoop out the board the tiny black plug is that come with together with your fingers. Place the board aside.

8. Disconnect the green plug connected to the board that is certainly now revealed when using the needle nosed pliers.

9. Perk up top cover. Separate the superior with the front cover from your circuit card. Place the front cover back down with both of the LCD screens facing upwards.

10. Pull the gray ribbon connector from the corner on the card utilizing your fingernail. Position the circuit card aside.

11. Eliminate the four screws from around the LCD screen on the front cover when using the Phillips jeweler's screwdriver.

12. Push on the back of the front cover to make a gap between the front cover along with the LCD frame assembly. jklzaeqc 1123

13. Insert the tip in the flat-edged screwdriver in the gap and wiggle it. Pull the front cover away from the LCD frame assembly together with your fingers. Position the LCD frame assembly with their face down about the towel.

14. Insert the end in the flat-edged screwdriver int an edged beneath back plate from the LCD screen.

15. Pry the LCD screen up and off of the LCD frame assembly.