How to Modify an Xbox Controller for Rapid Firing

Xbox 360 system owners have the choice of playing multiplayer “death” matches or to co-op certain games with a paid subscription to Xbox Live. Many hardcore gamers choose to modify their game xbox 360 controller for these games, like outfitting all of them rapid-fire buttons. These changes allow certain in-game weapons that normally fire round during a period, as being a sniper rifle, operate as if we were looking at automatic weapons. The mod requires physically switching your controller, a pursuit that will void any current warranty your digestive system has.

Instructions

1. Click and remove the rear battery compartment and hang it aside. Unscrew all seven screws on the rear with the controller and hang up the screws aside. Pry the controller casing apart, keeping the controller with their face down and keep several colored option buttons in situ.

2. Remove the colored buttons or place an item of tape in the buttons and keep them from falling out in clumps while working. Purchase a point in the top face with the controller in which you’d like your rapid fire button to become installed. A typical choice among many gamers is slightly to the left from the blue X button.

3. Drill a hole completely with the plastic shell at the spot you need to place the button. Put aside. Dab handful of glue to the peak on the push mechanism, then press on the plastic button. Thread the mechanism with the hole you merely drilled.

4. Crimp the ends of around bit of wiring about 2 inches long. Wrap one end from the exposed wire about the small prongs around the end of the button mechanism. Locate the tiny grayish dot at the top center, relating to the two black circles the spot that the thumbsticks normally rest.

5Heat your soldering iron. Heat the gun spanning a damp cloth to counteract any accidental burns for a work surface.

6. Solder the conclusion of the wire to the small dot and permit ample time with the solder to chill (about 30 minutes). Replace the colored buttons back into the controller face or remove the tape that held them in position. Attach the rear of the controller towards the front (again, while using front facedown) and re-screw all seven screws back to place. Attach battery compartment.

The best way to Alter the Player Number around the Xbox 360 system Wireless Controller

The Xbox 360's wireless controllers offer greater flexibility if you're doing offers because you're not tied to an electric cord. Unfortunately, when you want to vary the controller's port--indicating which controller is assigned to which player number--you should reprogram the controllers in the proper order. In comparison to simply "swapping plugs," this is often tedious, but it is little trouble. Each wireless controller is set using a quadrant about the Xbox ring of sunshine; your order in which they may be programmed dictates you number.

Instructions

1. Turn on your Xbox 360. Press and hold the "Guide" button in the center of your wireless controller until prompted to show rid of it. Select "OK."

2. Press and retain the "Guide" button on each additional wireless controller you have programmed to your Xbox one-by-one. Cut each controller.

3. Press and support the "Guide" button for the wireless controller you intend to set as "Player One." Hold off until the controller's green light activates, then press the "Connect" button in your Xbox 360 system, accompanied by the "Connect" button on your wireless controller.

4. Repeat accomplishing this to program around four wireless controllers. Program them employing the same method, from the order you'd like them for being to become numbered (controller two=player two; controller three=player three; controller four=player four).