How you can Replace a Nintendo DS Lite Case

The Nintendo DS Lite is really a small handheld computer game system that consists of a touchscreen LCD. Since the DS can be so small and contains such expensive components, it's only natural so it has a durable plastic ds lite case. But even this case is usually at risk from damage. If the case becomes damaged and requires to get replaced, you don't need to send it into a repair center; you are able to change it all on your own.

1. Shut off your Nintendo ds and set it facedown using a sturdy work surface for example a table or desk. ds lite bag

2. Occurs Phillips screwdriver to get rid of the screw on the rectangular battery compartment cover. Remove the cover plus the battery in the compartment.

3. Make use of the tip of this screwdriver to pop the rubber pads over two screws on top corners in the back of the DS. Then get rid of the screws.

4. Get rid of the three other screws about the sides and bottom from the back from the DS, along with the single screw perfectly located at the battery compartment.

5. Pull the back 1 / 2 true gently off the front and hang it aside. The board can be exposed inside front 50 % of true.

6. Locate the black wire that connects aside in the rectangular metal card slot and unplug it.

7. Make use of Phillips screwdriver to eliminate the 2 screws on spare on both on the plug-in that secure it to the housing.

8. Lift the circuit card perpendicularly, but don't erase it as it is still connected by way of a screen cable.

9. Unplug the orange LCD ribbon cable where it connects towards the bottom corner with the card. Take away the circuit card and set it aside.

10. Remove the screws about the plastic frame since the LCD screen then gently get rid of the frame on the front housing and screen. ds lite shell case

11. Use the tip of your screwdriver to pop a few rubber screw covers off of the screws on each corner of the front housing across the LCD screen.

12. Eliminate the four screws round the LCD screen.

13. Separate each halves with the front housing and set the trunk half aside to reveal the rear from the LCD screen as well as the speaker assembly.

14. Lift the speakers out of the housing and then pop the screen gently outside the housing also. Replace with housing (available from your Nintendo retailer or online) and reassemble from the reverse order you took it apart. jklzaeqc 1026