The best way to Replace a Nintendo ds lite Hinge

Getting the Nintendo DS's hinge break could be frustrating, as without, your DS will not likely stay open. That basically means your machine is actually unplayable. Because Nintendo ds lite case is all of 1 piece, you are unable to simply replace the hinge and move ahead. So that you can repair your hinge, you will find the replace your DS's shell entirely. Since replacing the shell is hard, it's recommended when at all possible, you return your DS back to Nintendo for repair. However, if this is not an alternative, replacing your DS's shell, and thus repairing its hinge, is doable.

Instructions

1. Lay your Ds lite as well as the replacement shell using a smooth, flat surface. When you place a towel or a mousepad under the new DS shell, it helps prevent it from being scratched in the installation process.

2. Get the seven screws for the back of one's DS. It will call for a a specialized Tri-wing screwdriver.

3. Pull the fewer section of your DS's shell apart, then set it aside.

4. Sign up for a few screws on the green board. These are highly visible because of the bright silver color. You'll be on the foot of the board, another about the right side, another on the left and also the final one at the top.

5. Disconnect the ribbon cable within the upper lefthand corner. Press the track of the edges in the ribbon cable to disconnect the clips, then pull against each other on the connector. Be gentle. If this cable rips, your DS will probably be ruined.

6. Press in at the base screen. After you make this happen, the screen and board will start up with the ds lite case ( http://www.vdealbox.com/ds-lite-accessories/ds-lite-housing-shell-case.html ). Set them aside.

7. Take away the screw in the gutter beneath the section of the shell when the board you only removed was sitting. Oahu is the only screw in the community, therefore it should be simple to find.

8. Turn your DS over and take away the screws each and every corner of the top screen. You will see four in all.

9. Pull the highest area of the shell apart and set it aside. jklzaeqc 1122

10. Get rid of the speakers and boards. Each board is locked in having a single highly visible screw. Once you remove that screw, the board will fall out. The speakers should be pried out. Be careful not to tear the speakers' wires and to maintain their loop.

11. Pry your top screen.

12. Lay down a narrow band out silicone adhesive throughout the groove from the new DS shell in which the screen is supposed to sit. Use a toothpick to make this happen neatly. Press the screen into the groove, making certain it's aligned properly, then wipe away any excess glue.

13. Created your DS in the new ds lite cases through using the directions in reverse.